EEVblog #931 – Designing A Better Multimeter PART 2

Dave takes a look at how to optimise the low burden voltage multimeter design from PART 2 to eliminate some parts.
And explains the µCurrent shunt circuit design and how that applies to this new optimised design.
It’s basically a practical tutorial in circuit design optimisation.
Then another design variation is presented using MOSFET switching that eliminates ones of the HRC fuses and the amplifier, and still lowers the burden voltage yet again!
PART 1 is here: https://www.youtube.com/watch?v=jx0dryLmUEQ
Forum: http://www.eevblog.com/forum/blog/eevblog-929-designing-a-better-multimeter/

EEVblog Main Web Site: http://www.eevblog.com
The 2nd EEVblog Channel: http://www.youtube.com/EEVblog2

Support the EEVblog through Patreon!
http://www.patreon.com/eevblog

EEVblog Amazon Store (Dave gets a cut):
http://astore.amazon.com/eevblogstore-20

T-Shirts: http://teespring.com/stores/eevblog

Leave a Comment / Question